S4ALL PRO All-In-One Hybrid Polymer Sealant & Adhesive

DescriptionPROPERTIESSingle component, easy to applyResistant to weather conditions and UV radiationCan be overpaintedDoes not contain solvent and isocyanate, long life, does not lose volume and massPermanently elasticTolerates movements in the joints and protects its isolation and adhesion properties thanks to its high modulusDoes not cause bubble after application that may be caused by damp surfacesExcellent adhesion to many building materialsAPPLICATION AREASIn sealing and bonding application both in outdoor and indoorIn floor jointsIn ship and boat yardsOn metal substrates as car body and containersFixing window steps, skirting boards and door fillets.In windows joineryIn pre-fabric constructionTECHNICAL DATAAppearanceMS Polymer SealantApplication Temperature 5°C and 35°CService Temperature-40°C and 80°CDensity1,40 ± 0,05 g/cm³Tack-Free Time (Minutes)~ 30Curing Rate3 mm / 24 hoursHardness (Shore A)40 ± 5Elongation at Break> 360%Elastic Recovery> 95%Elastic Modules 100%0,40 N/mm²SURFACE PREPARATIONEnsure that all surfaces intended for contact with the sealant are clean, dry, and free from oil, dust, and rustAny existing sealant on the surfaces must be removed using mechanical methodsUse masking tape to outline the application area. Remove the tape immediately after the application is completeFor certain surfaces, a primer may be necessary to enhance adhesion. Ensure the appropriate primer is selected for the specific applicationJOINT DESIGNThe minimum joint width for bonding should range from 2 mm to 10 mmJoint widths should fall between 6 mm and 20 mmFor joints with a width of up to 12 mm, the depth-to-width ratio is 1:1, with a minimum of 6 mm for both dimensions. For joints wider than 12 mm, the depth should be half the widthUse a polyethylene backer rod to control the sealant depth, achieve the desired joint profile, and prevent three-sided adhesionAPPLICATION METHODInsert the cartridge into the application gunApply the sealant in a continuous motion, moving in one direction, with sufficient pressure to fully fill and seal the jointThe product’s smooth consistency makes dry tooling the recommended techniqueRemove the masking tape after applicationClean any excess sealant from the surfaces immediately. Once cured, the sealant can only be removed mechanicallyWARNINGThis product should not be used in enclosed areas, as it cures through exposure to atmospheric humidityWhile it can be overpainted, the paint may crack if the joint undergoes movementSurfaces that release oil, solvents, or plasticizers may experience a loss of adhesion over timeSHELF LIFE AND STORAGEStore the product in its sealed packaging, in a cool, dry environment, at temperatures between 5°C and 25°CThe shelf life is 15 months from the production dateSAFETY INFORMATIONContains trace amounts of volatile chemicals. Ensure the application area is well-ventilated if used indoorsAvoid prolonged skin contact with uncured sealant, as it may cause irritationFor detailed information, refer to the safety data sheet (SDS)